Replacing The Camera-Part Number Cts1100-Cam; Required Tools; Removing And Replacing The Camera; Required Tools And Accessories - Cisco TelePresence System 1100 Assembly Manual

Replacing the Camera—Part Number CTS1100-CAM=
Table 6-1 List of FIeld-Replaceable Units for the Cisco TelePresence System (continued)
FRU Part Number
CTS-MIC-EXT=
CTS-PWR-INJ=
CTS-PWR-LT-LED=
CTS-PWR-PDU=
Replacing the Camera—Part Number CTS1100-CAM=
This section describes the steps you take to remove and replace the camera and contains the following
topics:
•
•

Required Tools

No tools are required to remove and replace the camera. For the list of tools you need to recalibrate the
camera, see the

Removing and Replacing the Camera

To remove the existing camera and replace it with a new camera, perform the following actions:
Remove the speaker cover. See
Step 1
Cisco TelePresence System 1100"
Disconnect the camera cable at the processor by pressing on the connector and pulling the cables apart.
Step 2
Step 3 Slide the camera forward until the slots in the metal camera bracket disengages from the grooves in the
CTS 1100 assembly. See
System 1100"
Take the new camera and slide it forward onto the camera bracket on the CTS 1100.
Step 4
Chapter 3, "Assembling and Mounting a Cisco TelePresence System 1100"
Connect the camera cables, using either the existing labels or the labels that you created in
Step 5
Replace the speaker cover.
Step 6
System 1100"
Level and recalibrate the camera by following the procedure in the
Step 7
page 4-12
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
6-4
Description
Microphone Extension Cable, 9.5 meters
Power Injector
Power Supply for the LED Light Fixtures for the Cisco TelePresence Systems 1100 and
1300
Power Distribution Unit for the Cisco TelePresence Systems
Required Tools, page 6-4
Removing and Replacing the Camera, page 6-4
"Required Tools and Accessories" section on page 4-2
Figure 3-40
for more information.
Figure 3-42
shows this step.
in Chapter 4, "First-Time Setup."
Figure 3-42 in Chapter 3, "Assembling and Mounting a
for an illustration that shows this removal.
in Chapter 3, "Assembling and Mounting a Cisco TelePresence
in Chapter 3, "Assembling and Mounting a Cisco TelePresence
Chapter 6 Field-Replaceable Unit Guide
in Chapter 4, "First-Time Setup."
Figure 3-40
shows this step.
Step
"Setting Up the Camera" section on
OL-19695-01
in
2.