Setting Up The Camera; Removing The Camera Cover And Leveling The Camera - Cisco TelePresence System 1100 Assembly Manual

Chapter 4 First-Time Setup

Setting Up the Camera

The camera is set up correctly when the image is centered and in focus on the display screen, and the
white balance is configured. The hardware setup software provides a camera Auto Adjust feature and
uses targets to adjust the camera zoom and fine-tune the camera focus.
To set up the camera for the CTS 1100, complete the procedure in the following sections:
•
•
•
•

Removing the Camera Cover and Leveling the Camera

The camera cluster must be perfectly level for you to properly configure the camera. To level the camera,
complete the following steps.
OL-19695-01
Removing the Camera Cover and Leveling the Camera, page 4-13
Attaching the Large Camera Target to the Easel, page 4-15
Performing Initial Focus Adjustments and Adjusting the Camera Zoom, page 4-17
Focusing the Camera, page 4-24
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
Setting Up the Camera
4-13