Attaching The Mounting Bracket To A Wall With Steel Studs - Cisco TelePresence System 1100 Assembly Manual

Attaching the Mounting Bracket to a Wall With Steel Studs

Step 9 Move the sliders and strips so that they align as closely as possible with the center of the table.
Using duct or other tape, tape the strip between the sliders into the slot in the bracket.
Step 10
Tip The tape prevents the sliders from moving when you install the light reflector.
Figure 3-8 Centering the Studs and Strips to Accommodate Table Placement
Continue to the
Step 11
installation.
Attaching the Mounting Bracket to a Wall With Steel Studs
This section contains the procedure you use to mount the MSP-CSC6 mounting bracket to the wall using
steel studs.
Before starting this procedure, be sure to read the guidelines for walls with steel studs in the
Warnings and Cautions" section on page
To attach the mounting bracket to the wall, perform the following steps:
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
3-14
Bracket
Bracket
"Attaching the Light Reflector, Display, and Cabinet" section on page 3-27
3-1.
Chapter 3 Assembling and Mounting a Cisco TelePresence System 1100
Sliders
Table
Sliders
Table
to complete
"Important
OL-19695-01