Post-Three Toner Sensors Not Connected Error Service Check - Lexmark X734de Service Manual

920.10—POST—Three toner sensors not connected error service check
Step Questions / actions
Remove the left cover. See
1
removal" on page
sensor cables (A) connected to the rear of the
HVPS.
Are any of the cables damaged?
Disconnect one of the toner level sensors,
2
and POR the MFP. See
removal" on page
Does the 910.10 error occur again?
"Left cover
4-23. Check all toner level
"Toner level sensor
4-174.
Yes
If one or two of the toner
level sensor are damaged:
• Disconnect the
sensor(s), and
• Go to step 2.
If two toner level sensors
are damaged, replace the
damaged sensor. See
"Toner level sensor
removal" on page 4-174.
Then this is one of the
three bad toner level
sensors. Continue
disconnecting the toner
level sensors until three
sensors are disconnected
and the 920.10 error
occurs.
Replace the toner level
sensors that are
disconnected. See
"Toner
level sensor removal" on
page 4-174.
7526
No
Go to step 2.
Repeat this step for the
other toner level sensors
until the 920.10 error
occurs.
Diagnostic information
2-113
Previous
Next
Go Back