Lexmark X734de Service Manual page 58

7526
Error code
168.xx
Motor Error
199.xx
Software Error
2xx paper jam messages
200.02
200.11
200.17
200.21
200.22
Service Manual
2-20
Description
HCIT elevator motor error.
Unrecoverable RIP software error.
Input sensor is made when printer
tries to print from an idle state.
Possible causes:
• Paper jam leaving page over
sensor
• Defective input sensor
• Faulty system board
Input sensor does not break.
Possible causes:
• Incorrect media setting
• Incorrect paper loading
• Incorrect media restraint setting
• Transport belt module failure
• Lower guide failure
• Paper pick mechanism failure
• Input sensor failure
Input sensor is made when printer
powers up or covers are closed.
Possible causes:
• Paper jam leaving page over
sensor
• Defective input sensor
• Faulty system board
Aligner motor stalled.
Possible causes:
• Faulty cable/connector
• 24 V interlock switch not working
correctly
• Faulty aligner motor
• Faulty system board
• Waste toner not seated.
Pick (tray 1) motor stalled.
Possible causes:
• Faulty cable/connector
• Faulty pick motor
• Faulty system board
Action
• POR the printer.
• If the message persists, go to
(HCIT elevator) error service check" on
page 2-63.
• POR the printer.
• If the error message persists, download the RIP
code again.
• Clear away anything in the paper path that might
cause the paper to jam.
• If clearing a paper jam does not fix the problem,
go to
"Input sensor service check" on
page 2-147.
• Clear away anything in the paper path that might
cause the paper to jam.
• Ensure proper media is set for the type of paper
used.
• Fan media, and stack flat in the tray.
• Properly set media restraints in the paper tray.
• Check the pick tires and replace if worn.
• If the message persists, go to
Paper Jam error service check" on
page 2-64.
• Clear away anything in the paper path that might
cause the paper to jam.
• If clearing a paper jam does not fix the problem,
go to
"Input sensor service check" on
page 2-147.
• Check that the waste toner is latched correctly in
the printer.
• Check for anything in the paper path that might
cause the paper to jam.
• If clearing a paper jam does not fix the problem,
go to
"147.xx, 920.01—Motor (aligner) error
service check" on page
• Check for anything in the paper path that might
cause the paper to jam.
• If clearing a paper jam does not fix the problem,
go to
"140.xx, 920.02—Autocomp (tray 1)
motor error service check" on page
"168.xx—Motor
"200.11, 250.03—
2-55.
2-46.
Previous
Next
Go Back