Hcit Slide Assembly With Spring Removal - Lexmark X734de Service Manual

HCIT slide assembly with spring removal

Remove the HCIT controller board assembly. See
1.
page 4-295.
Disconnect the two springs (A) from the frame.
2.
Note: Leave the springs attached to the cam size sensing plate (B) and the actuator switch.
Slide the cam size sensing plate (B) through the access hole in the rear side frame.
3.
4. Remove the media size actuator from the card mount option (C).
Snap loose the actuator switch (D), and remove.
5.
"HCIT controller board assembly removal" on
Repair information
7526
Previous
Next
Go Back
4-299