Fuser Dc Cable Removal - Lexmark X734de Service Manual

Fuser DC cable removal

Note: The fuser to system board autoconnect cable is red.
1. Remove the top cover assembly. See
Turn the top cover assembly over.
2.
Remove the connector (A) from the top cover assembly.
3.
Warning: You will damage the old connector in the process. Be careful not to damage the top cover
assembly.
Pull the cable through the openings (B) in the top cover assembly.
4.
"Top cover assembly removal" on page
7526
4-48.
Repair information
4-117
Previous
Next
Go Back