Lexmark X734de Service Manual page 64

7526
Error code
242.05
242.10
242.11
242.17
242.26
242.27
Service Manual
2-26
Description
Tray 2 picked, but page failed to reach
the option sensor in time.
Possible causes:
• Incorrect media setting
• Incorrect paper loading
• Incorrect media restraint setting
• Faulty paper pick mechanism
Tray 2 page exits pass thru made
early.
Possible causes:
• Defective pass thru sensor
• Faulty cable in the connector
OPT1 on system board.
Tray 2 sensor never broke.
Possible causes:
• Incorrect tray 2 media setting
• Incorrect Tray 2 paper loading
• Incorrect media restraint setting
• Paper tray failure
• Aligner failure
• Transport belt module failure
• Loading card stock from the
special media tray above the fill
line.
• High humidity (replace paper)
Tray 2 detected a jam from idle.
Possible causes:
• Paper jam leaving page over
sensor
• Defective input sensor
• Faulty system board
While feeding from tray 2, the pass
thru sensor is not made.
Possible causes:
• Incorrect paper loading for lower
tray
• Incorrect media restraint setting
for lower tray
• Paper tray 2 assembly failure
• Lower tray 3 assembly failure
While feeding from a lower tray, the
pass thru sensor did not break.
Possible causes:
• Paper tray 2 assembly failure
(feed thru roller)
• Aligner failure
• Transport belt motor failure
Action
• Ensure proper media is set for the type of paper
used in tray 2.
• Fan media, and stack flat in tray 2.
• Properly set the media restraints in tray 2.
• Check the pick tires in tray 2 and replace if worn.
• If the previous actions do not fix the problem, go
to
"242.05—Paper Jam service check" on
page 2-74.
• Ensure the proper media is set for the type of
paper used in tray 2.
• Check for anything in the paper path that might
cause the paper to jam.
• The exits pass thru sensor may not be
functioning properly. Go to
Jam service check" on page
• Ensure the proper media is set for the type of
paper used in tray 2.
• Fan media, and then stack flat in tray 2.
• Properly set the media restraints in tray 2.
• If the problem persists, go to
Paper Jam service check" on page
• Clear away anything in the paper path that might
cause the paper to jam.
• If clearing a paper jam does not fix the problem,
go to
"242.17—Paper Jam service check" on
page 2-76.
• Clear away anything in the paper path that might
cause the paper to jam.
• Ensure the proper media is set for the type of
paper used in the lower tray.
• Fan the media, and then stack flat in the lower
tray.
• Properly set the media restraints in the lower
tray.
• Check the pick tires in the lower tray, and then
replace if worn.
• If clearing a paper jam does not fix the problem,
go to
"242.26—Paper Jam service check" on
page 2-77.
• Clear away anything in the paper path that might
cause the paper to jam.
• Reseat option tray 2.
• If the problem persists, go to
Jam service check" on page
"242.10—Paper
2-75.
"242.03, 242.11—
2-73.
"242.27—Paper
2-77.
Previous
Next
Go Back