Adjust Printable Range For Each Speed Level (Full Speed / Half Speed For Thick Paper / Quiet Mode) (Function Code: 46) - Brother DCP-L5500D Service Manual

1.3.14 Adjust printable range for each speed level
(Full speed / Half speed for thick paper / Quiet Mode) (function code: 46)
<Function>
This function is to adjust the printing position in horizontal / vertical direction when it's
misaligned on Full speed, Half speed for thick paper, or Quiet Mode.
Position can be adjusted in 11 steps from -0.5% to 0.5% (Negative value → Printing width
gets smaller).
<Operating Procedure>
(1) Press the [4], and then the [6] key in the initial state of maintenance mode. "1.PrtSzAdj
Nomal" is displayed on the LCD.
(2) Press the [▲] or [▼] key to display desired speed on the LCD.
• Full speed → "1.PrtSzAdj Nomal"
• Half speed for thick paper → "2.PrtSzAdj THalf"
• Quiet Mode → "3.PrtSzAdj QHalf"
Press the [Mono Start] key. "*.1 *:Main" is displayed on the LCD.
Selected speed is displayed for "*".
(3) Press the [▲] or [▼] key to display "*.3 *:Print" on the LCD, and press the [Mono Start]
key. "PRINTING" is displayed on the LCD, and the print adjustment test pattern (refer to
the next page) is printed on a sheet of paper.
(4) Adjust the line so that the width is 10mm in horizontal / vertical direction.
Press the [▲] or [▼] key to display desired direction on the LCD.
• Horizontal direction → "*.1 *:Main"
• Vertical direction → "*.2 *:Sub"
Press the [Mono Start] key. "0.0 %" is displayed on the LCD.
(5) To make the print width smaller, press the [˅] key to decrease the value. Press the
[Mono Start] key after adjusting the value.
(6) Press the [X] key to return the machine to the initial state of maintenance mode after
adjusting the value.
5-27
Confidential