Table of Contents
Advertisement
9.12 Panel unit
9.12.1Panel unit
(1) Remove the four taptite cup B M3x10 screws.
(2) Release the three hooks to remove the panel unit. Disconnect the panel flat cable from
the panel PCB ASSY.
Note:
• Flat cable is connected to the panel unit. Do not pull the panel unit too hard when
removing it.
(3) Release the panel flat cable from the securing fixtures.
Panel flat cable
Harness routing: Refer to
Assembling Note:
• If you replaced the panel unit, refer to
OR PANEL PCB" in chapter 4
Hooks
Panel PCB ASSY
Fig. 3-50
"5. Document scanner
and configure the setting.
Hooks
Panel flat cable
unit",
"6. Panel unit (4.85 inch
"4. IF YOU REPLACE THE LCD PANEL ASSY
3-56
Panel unit
Taptite cup B M3x10
model)".
Confidential
Advertisement
Table of Contents
Troubleshooting
