Adf Unit - Brother DCP-L5500D Service Manual

9.11 ADF unit

9.11.1 ADF unit
(1) Remove the taptite bind B M4x12 screw (black) from the hinge L ASSY.
(2) Open the ADF unit. Lift the ADF unit and release each hook to remove the flat cable
holder from the document scanner unit.
(3) Lift the ADF unit to remove the ADF unit from the document scanner unit while pressing
the hinge R hook. Pull out each harness from the hole.
(4) Release the ADF sensor harness and second side CIS flat cable* from the flat cable
holder.
ADF unit
ADF sensor harness
Flat cable holder
Taptite bind B
M4x12 (black)
Harness routing: Refer to
Assembling Note:
• If you replaced the ADF unit, refer to
SIDE CIS UNIT, SECOND SIDE CIS UNIT OR DOCUMENT SCANNER UNIT" in
chapter 4 and configure the setting.
Hinge R
Hinge L ASSY
Second side
CIS flat cable*
Hooks
Fig. 3-33
"1. ADF unit - Main PCB
"5. IF YOU REPLACE THE ADF UNIT, FIRST
3-43
Hook
Document scanner unit
* Models with duplex scanning only
ASSY".
Confidential