Fuser Drive Gear 39 - Brother DCP-L5500D Service Manual

9.35 Fuser drive gear 39

(1) Remove the three taptite bind B M4x12 screws and two taptite cup S M3x8 SR screws.
Release the two hooks to remove the main PCB shield calking ASSY from the main
frame L ASSY.
Note:
• Do not allow the metallic gear shaft of the main PCB shield calking ASSY to face
down. Failure to observe this may cause the steel plate to bend.
Taptite bind B
M4x12
Hooks
Assembling Note:
• When securing the main PCB shield calking ASSY with screws, tighten the screws in
the sequence of the numbers engraved on the main PCB shield calking ASSY.
Main PCB shield calking ASSY
Fig. 3-103
3-103
Taptite cup S M3x8 SR
Main PCB shield calking ASSY
Main frame L ASSY
5
4
2
1
3
Confidential