Aidc Process; Te Clear; Calibration; Coverage - Konica Minolta BIZHUB C3100P Service Manual

5. Using the up key/down key, vary the setting value.
• To increase the ATVC value, increase the setting value.
• To decrease the ATVC value, decrease the setting value.
6. Press the Menu/Select key to validate the setting value.
7. Check the print image for any image problem.

3.6.4 AIDC PROCESS

(1) Use
• To carry out an image stabilization sequence after the historical data of image stabilization control has been initialized.
• Use if an image problem persists even after gradation adjustment has been executed.
• Use if tone reproduction and maximum density are faulty even after stabilizer mode has been executed.
• When color shift correction is needed again after the machine maintenance.
(2) Setting item
• 600dpi
• 1200dpi
• CANCEL
(3) Procedure
1. Call [SERVICE MODE] to the display.
2. Select [SYSTEM 2] -> [AIDC PROCESS].
3. Select [600dpi] or [1200dpi] by using the up key/down key, and press the Menu/Select key.
4. The image stabilization is executed.

3.6.5 TE CLEAR

(1) Use
• To release the empty status temporarily when a toner cartridge comes empty.
(2) Default setting
• CANCEL
(3) Setting item
• EXCUTE
• "CANCEL"

3.6.6 CALIBRATION

(1) Use
• To change the type and timing of image stabilization.
• To provide the desirable image stabilization control that depends on customer's machine usage pattern, i.e. the ratio of color to black
print.
STANDARD
MONOCHROME
(2) Default setting
• STANDARD
(3) Setting item
• "STANDARD"
• MONOCHROME

3.6.7 COVERAGE

(1) Use
• To set whether or not to display a coverage rate on the Counter List.
(2) Default setting
• OFF
(3) Setting item
• ON
• "OFF"
This mode is suitable for low-volume users and
reduces the number of times image stabilization is
carried out when the main power switch is turned
ON.
This mode is suitable for users who use mainly black
print and use less color print. It provides
monochrome stabilization and reduces the number of
times image stabilization is carried out when the main
power switch is turned ON.
I ADJUSTMENT/SETTING > 3. SERVICE MODE
If the change of absolute humidity is detected during
warm-up, normal stabilization is performed during
warm-up.
If the change of absolute humidity is detected during
warm-up, monochrome stabilization is performed
during the warm-up and color stabilization is
performed before color printing.
I-18