4 Replacement Procedures
4.12 MDC board
Removing the MDC board
To remove the MDC board, follow the steps below and refer to Figure 4-19.
1. Remove the following screws and disconnect the MDC board from the connector
2. Disconnect the MDC cable from the connector on the MDC board.
Installing the MDC board
To install the MDC board, follow the steps below and refer to Figure 4-19.
1. Connect the MDC cable to the MDC board.
2. Install the MDC board to the connector CN3010 on the MP FPC and secure it with
4-30
Downloaded from
www.Manualslib.com
CN3010 on the MP FPC.
•
M2×3C
M2×3C S-FLAT HEAD
Figure 4-19 Removing the MDC board
the following screws.
•
M2×3C
[CONFIDENTIAL]
manuals search engine
S-FLAT HEAD screw
CN3010
S-FLAT HEAD screw
PORTEGE R200 Maintenance Manual (960-519)
4.12 MDC board
x2
M2×3C S-FLAT HEAD
MDC board
MDC cable
x2