4 Replacement Procedures
4.16 MP FPC
Removing the MP FPC
To remove the MP FPC, follow the steps below and refer to Figure 4-23.
1. Remove the following screw and kill switch holder.
2. Remove the following screws and disconnect the MP FPC from the connector
4-34
Downloaded from
www.Manualslib.com
•
M2×3C
CN9500 on the system board.
•
M2×3C
M2×3C S-FLAT HEAD
Figure 4-23 Removing the MP FPC
[CONFIDENTIAL]
manuals search engine
S-FLAT HEAD screw
S-FLAT HEAD screw
Kill switch holder
CN9500
PORTEGE R200 Maintenance Manual (960-519)
4.16 MP FPC
x1
x2
M2×3C S-FLAT
HEAD
MP FPC