Antennas' Connection Check - Toshiba PORTEGE R200 Maintenance Manual

2 Troubleshooting
Procedure 2
The Bluetooth function-wiring diagram is shown below:
Any of the connections may be defective. Disassemble the computer following the steps
described in Chapter 4, Replacement Procedures, and perform the following checks:
Check 1
Check 2
Check 3
2-50
Downloaded from www.Manualslib.com

Antennas' Connection Check

Make sure that the wireless communication switch is "On".
If the switch is "Off", turn it "On". If the problem still occurs, perform Check 2.
Make sure that Bluetooth module is firmly connected to the CN4400 on the
system board. If the connector is defective, connect it firmly and perform
Procedure 1. If the problem still occurs, perform Check 3.
Make sure that Bluetooth antenna cable is firmly connected to the connector on
the Bluetooth module. If the Bluetooth antenna cable is not connected properly,
connect it firmly and perform Procedure 1. If the problem still occurs, go to the
procedure 3.
[CONFIDENTIAL]
manuals search engine
2.13 Bluetooth Troubleshooting
PORTEGE R200 Maintenance Manual (960-519)