Hard Disk Test - Toshiba PORTEGE R200 Maintenance Manual

3.13 Hard Disk Test

3.13 Hard Disk Test

To execute the Hard Disk Test, select 8 from the DIAGNOSTIC TEST MENU, press Enter
and follow the directions on the screen.
CAUTION: The contents of the hard disk will be erased when subtest 02, 03, 04, 06, 08
The following messages will appear after selecting the hard disk test from the DIAGNOSTIC
TEST MENU.
1. Select the drive number and press Enter.
2. The following message appears for the error dump operation when a data compare
3. The following message appears for whether or not the HDD status is displayed on the
PORTEGE R200 Maintenance Manual (960-519)
Downloaded from www.Manualslib.com
or 09 is executed. Before running the test, the customer should transfer the
contents of the hard disk to floppy disk or another hard disk. If the customer
has not or cannot perform the back-up, create back-up disks as described
below.
Check to see if the Microsoft Create System Disks Tools (MSCSD.EXE) still
exists in the System Tools Folder. (This tool can be used only once.) If it
exists, use it to back up the pre-installed software, then use the Backup
utility in the System Tools folder to back up the entire disk, including the
user's files.
Refer to the operating system instructions.
Test drive number select
error is detected. Select 1 or 2.
Data compare error dump (1:no, 2:yes)
screen. The HDC status is described in section 3.20. Select 1 or 2.
Detail status display
manuals search engine
(1:HDD#1, 2:HDD#2, 0:HDD#1&2)?
(1:no, 2:yes)
[CONFIDENTIAL]
3 Tests and Diagnostics
3-27