Programming The Secondary Filter - Jacuzzi J-495 Owner's Manual

3. Tap to program the end time for the cycle.
End
4. Tap the hour block to change the end time.
5. Tap or
"AM" to "PM" you must round a 12-Hour period.
6. Tap to confirm and save your changes.
7. Tap to return to the Heat & Filter Menu. Tap again to return to the
Settings Menu.
Summer Logic: In warm weather, the water temperature in the spa
may exceed the set temperature. This condition may occur due to
heat transference from the filter/circulation pump and jets pumps.
If the water temperature is higher than 95°F (35°C) and rises two
degrees above the set temperature, a "Summer Logic" condition
occurs that deactivates the filter/circulation pump and CLEARRAY®.
This safety feature cannot be altered! The filter/circulation pump and
CLEARRAY® will remain off until the water temperature cools to the
set temperature (except between 9am-11am when the filter/circulation
pump runs for it's mandatory 2 hour cycle.) To help prevent a "Summer
Logic" condition, it may be necessary to reduce filter/circulation pump
cycles run times in warm weather.
12.3

Programming the Secondary Filter

To access the "Secondary Filter" feature, tap
Menu, Figure 12.3a, to enter the "Secondary Filter" programming, Figure
12.3b.
Figure 12.3a
During a secondary filtration, the Jets Pump 1 is activated. There are
3 cycles you can select from, Figure 12.3b. The factory default cycle
is "Away Mode." If you elect to keep this setting, then you can skip this
section.
Indicates that the feature is active.
active.
A. To change the Secondary Filter cycle:
1. Away Mode: Secondary Filtration is disabled. To activate this mode,
tap next "Away." This is the factory default setting.
2. Infrequent Mode: Activates two cycles at 8:00 PM and 8:00 AM every
other day. Each cycle will last 10 minutes for a total of 20 minutes
every other day. To activate this mode, tap
Time and duration cannot be altered.
to change the hour in 1-hour increments. To switch from
Heat & Filter
Auto
Econo
Day
2
Filter
1
from the Heat & Filter
2
Secondary Filter
Infrequent
Frequent
Away
Figure 12.3b
Indicates that the feature is not
next to "Infrequent."
J-400
Page 53