Removing The Driven Pulley Shaft Bearing - PIAGGIO X8 125 Workshop Manual

X8 125-200
- Remove the 5 screws, found on two different lev-
els, as well as the small casing.
- To remove the intake throat on the transmission
cover, just remove the 2 fixing screws indicated in
the figure.

Removing the driven pulley shaft bearing

- Remove the clip from the inside of the cover.
- Remove the bearing from the crankcase by
means of:
Specific tooling
020376Y Adaptor handle
020375Y Adaptor 28 x 30 mm
020412Y 15 mm guide
Engine
ENG - 93