Suspensions
- Heat the bearing seat on the odometer drive side
with the heat gun.
- Insert the two bearings using the punch consist-
ing of adaptor handle, 32x35 mm adaptor and 15
mm guide, and drive it up to the stop.
Specific tooling
020376Y Adaptor handle
020357Y 32x35-mm Adaptor
020412Y 15 mm guide
- Refit the cap and tighten the five fixing screws.
Refitting the front wheel
•
Check that the seal of the relative con-
tact track on the wheel of the odometer
transmission is in good condition.
•
Insert the wheel axle, after greasing it,
from the side of the clamp on the fork
leg and also insert the transmission it-
self.
•
-Tighten the wheel axle nut to the pre-
scribed torque.
Locking torques (N*m)
SUSP - 192
X8 125-200