PIAGGIO X8 125 Workshop Manual page 89

X8 125-200
•
Remove the holding spring and move
the petrol feed pipe to carburettor;
•
Cut the plastic clamp and disconnect
the starter supply connection.
•
Loosen the two screws fixing the rear
shock-absorbers to the crankcase and
the mounting arm;
•
Cut the zip-tie on the transmission air
duct, and then detach the manifold
from the air intake on the frame.
•
Disconnect the electric connector link-
ing the magneto flywheel to the vehicle
cable harness.
•
Remove the starter motor electrical
connections operating on the two
screws.
•
Remove the footrest and the left side
fairing; move the lower central cover
slightly to the outside; after that, re-
move the three supporting plate fixing
screws from the swinging arm buffer.
Remove the buffer seal seeger ring
Engine from vehicle
ENG VE - 89