License Plate Holder - PIAGGIO X8 125 Workshop Manual

X8 125-200
•
Undo screw «E» under the turn indica-
tor.
•
Remove the four screws «F», then re-
move the side panel by pulling it back-
wards to free the teeth hooking it to the
central cover.
See also
Handles and top side fairings
License plate light

License plate holder

•
Remove the rear and side fittings and
the pipe above the helmet compart-
ment retaining frame;
•
Remove the two side licence plate sup-
port clamping screws;
•
Lift the helmet compartment to allow
the licence plate support to free itself
from the two threaded appendages on
the rear frame tube.
Air filter
•
Remove the left-hand side panel;
•
Undo the three screws fixing the box to
the crankcase;
•
Loosen the hose tightening screw on
the carburettor and remove the hose;
•
Push the box upwards to free it from
the appendages on the crankcase and
remove it ;
Chassis
CHAS - 231