Removing The Driven Pulley Shaft Bearing - PIAGGIO X7 250ie Service Station Manual

X7 250ie
- Remove the transmission cover.
N.B.
WHEN YOU ARE REMOVING THE TRANSMIS-
SION COVER YOU MUST BE CAREFUL NOT
TO DROP THE CLUTCH BELL.
Air duct
- Remove the transmission compartment air intake
cover shown in the photograph.
- Remove the five screws on two different levels
as well as the small casing.

Removing the driven pulley shaft bearing

- Remove the clip from the inside of the cover.
- Remove the bearing from the crankcase by
means of:
Specific tooling
020376Y Adaptor handle
020375Y Adaptor 28 x 30 mm
020412Y 15 mm guide
Downloaded from www.Manualslib.com manuals search engine
Engine
ENG - 3