Rear Brake Calliper - PIAGGIO X8 125 Workshop Manual

Braking system
This section è is devoted to the description of the braking system components.

Rear brake calliper

Removal
Proceed as follows:
- remove the exhaust pipe;
- loosen fitting and detach brake lines, without
spilling any brake fluid on the tyre;
- remove the two fixing screws hence detach the
brake calliper.
Refitting
- Fit the calliper by tightening the two clamping
screws,
- fit the brake piping by means of the fitting screw,
- bleed the rear brake circuit,
- refit the muffler
N.B.
WHEN FITTING THE BRAKE TUBING, BE CAREFUL THAT
IT PASSES EQUIDISTANT BETWEEN THE UPPER SUS-
PENSION SUPPORT ARM BRANCH AND THE MUFFLER
BRACKET AND THAT IT PASSES PROPERLY THROUGH
THE CABLE HOLE IN THE FRAME.
Locking torques (N*m)
Rear brake calliper fixing screws
brake calliper-pipe fitting
clamping screws
27 ÷ 30
Front brake calliper
BRAK SYS - 206
Rear
20 ÷ 25
Muffler arm
20 ÷ 25
X8 125-200