X8 125-200
Check the diameters of both the driving shaft ends
according to the axes and planes shown in the fig-
ure. Half-shafts are classified into two categories,
Cat. 1 and Cat. 2. The table is shown below.
Characteristic
Standard diameter (125 - 200) Cat. 2
29.004 ÷ 29.010
Cat. 1 - Standard diameter (125-200) evo
28.994 ÷ 29.000
Specification
Standard diameter (125 - 200) Cat. 2
Cat. 1 - Standard diameter (125-200) evo
Inspecting the crankshaft alignment
Measure the capacity of both axes X-Y
Specific tooling
020074Y Support base for checking crankshaft alignment
Titolo
Crankshaft alignment
STANDARD DIAMETER
C
RANKSHAFT ALIGNMENT
Durata/Valore
Testo Breve (< 4000 car.)
Desc./Quantity
29.004 ÷ 29.010
28.994 ÷ 29.000
Indirizzo Immagine
ENG - 147
Engine