Removing The Driven Pulley Shaft Bearing - PIAGGIO MSS X9 Evolution 250 Workshop Manual

Engine
- To remove the intake throat on the transmission
cover, just remove the 3 fixing screws indicated in
the figure.

Removing the driven pulley shaft bearing

- Remove the clip from the inside of the cover.
- Remove the bearing from the crankcase by
means of:
Specific tooling
020376Y Adaptor handle
020375Y Adaptor 28 x 30 mm
020412Y 15 mm guide
Refitting the driven pulley shaft bearing
- Slightly heat the crankcase from the inside so as
not to damage the painted surface.
- Insert the bearing in its seat.
- Refit the seeger ring.
CAUTION
USE AN APPROPRIATE REST SURFACE TO AVOID DAM-
AGING THE COVER PAINT.
N.B.
ALWAYS REPLACE THE BEARING WITH A NEW ONE
UPON REFITTING.
Specific tooling
020376Y Adaptor handle
020357Y Adaptor 32 x 35 mm
020412Y 15 mm guide
Baffle roller
ENG - 82
Downloaded from www.Manualslib.com manuals search engine
MSS X9 Evolution 250