Rear Brake Calliper - PIAGGIO Beverly Tourer 125 Service Station Manual

Beverly Tourer 125
Interventions rules
WARNING
BRAKING SYSTEM FLUID IS CORROSIVE: ALWAYS WEAR PROTECTIVE GLOVES. IN THE
EVENT OF ACCIDENTAL CONTACT WITH YOUR EYES, RINSE THE CONTACT AREA WELL
WITH ABUNDANT WATER.
THE BRAKE FLUID DRAINED FROM THE SYSTEM IS HARMFUL TO THE ENVIRONMENT. COL-
LECTION AND DISPOSAL MUST BE CARRIED OUT IN COMPLIANCE WITH THE REGULATIONS
IN FORCE. UNDER NORMAL DRIVING AND CLIMATIC CONDITIONS YOU SHOULD CHANGE
THE FLUID EVERY TWO YEARS. IF BRAKES ARE USED INTENSELY AND/OR IN HARSH CON-
DITIONS, CHANGE THE FLUID MORE FREQUENTLY.
DURING INSTALLATION, THE PARTS TO BE REUSED MUST BE ABSOLUTELY CLEAN AND
FREE FROM ANY TRACES OF OIL, FUEL AND GREASE: IT IS THEREFORE NECESSARY TO
CLEAN THEM THOROUGH WITH DENATURED ALCOHOL.
N.B.
FOR TOPPING UP AND CHANGE, USE ONLY BRAKE FLUID DOT4 - NHTSA 116.
OBSERVE THE MAXIMUM DEGREE OF CLEANLINESS. HYDRAULIC FLUID IS EXTREMELY
CORROSIVE FOR PAINTED SURFACES.
BRAKE FLUID IS HYGROSCOPIC; THAT IS, IT ABSORBS MOISTURE FROM THE SURROUND-
ING AIR.
IF THE MOISTURE CONTENT IN THE BRAKE FLUID EXCEEDS A CERTAIN VALUE, IT WILL RE-
SULT IN POOR BRAKING EFFICIENCY DUE TO A LOW BOILING POINT OF THE FLUID.
N.B.
ALWAYS USE FLUID FROM SEALED CONTAINERS.
N.B.
RUBBER PARTS SHOULD NEVER BE LEFT IN ALCOHOL LONGER THAN 20 SECONDS. AFTER
WASHING, THE PIECES MUST BE DRIED WITH A BLAST OF COMPRESSED AIR AND A CLEAN
CLOTH.
THE SEAL RINGS MUST BE IMMERSED IN THE OPERATING FLUID; THE USE OF PRF1 PRO-
TECTIVE DEVICE IS ALLOWED.
WARNING
THE PRESENCE OF BRAKE FLUID ON THE DISC OR BRAKE PADS REDUCES BRAKING EFFI-
CIENCY. IN THIS CASE, REPLACE THE PADS AND CLEAN THE DISC WITH A HIGH-QUALITY
SOLVENT.

Rear brake calliper

Removal
- Remove the rear wheel.
- Remove the two rear brake calliper devices fas-
tening them to the support as shown in the photo-
graph.
N.B.
SHOULD THE BRAKE CALLIPER BE REPLACED, BEFORE
REMOVING THE FITTINGS FIXING THE CALLIPER TO THE
SUPPORTING BRACKET, FIRST LOOSEN THE OIL HOSE
FITTING AFTER HAVING EMPTIED THE SYSTEM OF THE
CIRCUIT BEING INSPECTED.
Braking system
BRAK SYS - 207