Change Your Controller Lan Ip Address; Upgrade Your Controller Firmware - TRENDnet TEW-755AP2KAC User Manual

TRENDnet User's Guide

Change your controller LAN IP address

Management > LAN
This section allows you to change your controller LAN IP address settings. Typically, the
IP address settings should be changed to match your existing network subnet in order to
access the switch management page on your network.
Default Controller IP Address: 192.168.10.200
Default Controller IP Subnet Mask: 255.255.255.0
1. Log into your controller management page (see
management page" on page 12).
2. Click on Management and click on LAN.
3. Review the settings. When you have completed making changes, click Apply to save
the settings.
 IP Address: Enter the new controller IP address. (e.g. 192.168.200.200)
 Netmask: Enter the new controller subnet mask. (e.g. 255.255.255.0)
 Gateway: Enter the default gateway IP address. (e.g. 192.168.200.1 or typically
your router/gateway to the Internet).
 DNS1/DNS2: Enter the primary and secondary DNS servers IP address in order to
resolve domain or host names. (e.g. 192.168.200.20)
© Copyright 2017 TRENDnet. All Rights Reserved.
"Access you wireless controller
TEW-755AP2KAC / TEW-821DAP2KAC

Upgrade your controller firmware

Management > Maintenance
TRENDnet may periodically release firmware upgrades that may add features or fix
problems associated with your TRENDnet controller model and version. To check if
there is a firmware upgrade available for your device, please check your TRENDnet
model and version using the link. http://www.trendnet.com/support.
In addition, it is also important to verify if the latest firmware version is newer than the
one your controller is currently running. To identify the firmware that is currently
loaded on your controller, log in to the controller, click on the Administrator section and
then on the Status. The firmware used by the controller is listed at the top of this page.
If there is a newer version available, also review the release notes to check if there were
any new features you may want or if any problems were fixed that you may have been
experiencing.
1. If a firmware upgrade is available (http://www.trendnet.com/support), download the
firmware to your computer.
2. Unzip the file to a folder on your computer.
3. Log into your controller management page (see
management page" on page 12).
4. Click on Management and click on Maintenance.
5. Depending on your web browser, in the Firmware Management section, click Browse
or Choose File.
"Access you wireless controller
13