Fault Code Charts - Genie Z-30/20N Service Manual

Service Manual
Fault Codes
Fault Code Chart Faul t Code C harts
Fault Code Programmer
Diagnostic Display
Fault code LED COMMUNICATION
is off or is on, but ERROR
not blinking
1
12 HW FAILSAFE 1-2-3
13 M- SHORTED
FIELD OPEN
ARM SENSOR
FLD SENSOR
96
Condition
Machine will not drive.
Normal operation.
Machine will not drive.
Machine will not drive.
Machine will not drive.
Machine will not drive.
Machine will not drive.
Z-30/20N • Z-30/20N RJ • Z-34/22 • Z-34/22N
Possible Causes Solution
The key switch or Push in the ground
Emergency Stop control red Emergency
button(s) was cycled Stop button to the off
on and off faster than position and wait for
5 seconds OR 5 seconds. Pull out the
controller sensed an ground control red
internal error during Emergency Stop
start up. button to the on
position. If problem
persists, replace the
motor controller.
The motor controller Replace the motor
failed self test. controller.
The motor controller Test the motor
has a internal short controller. See Repair
between M- and B- Section.
terminals.
Motor wiring is loose Check for loose or
OR motor is defective open connections at
OR motor controller the drive motors and
has an internal short. motor controller OR
replace the defective
drive motor OR test the
motor controller. See
Repair Section.
Defective motor Replace the motor
controller. controller.
Defective motor Replace the motor
controller. controller.
April 2016
Part No. 139378