Options For Switching Between Frames On The Skp Operating Terminal - Fujitsu S140 User Manual

Using frames

6.3.3 Options for switching between frames on the SKP operating terminal

The following table shows the options for switching to another frame on the SKP operating
terminal.
Operation
P2
P3
F3
Frame selection
Change to
subframes
FR command
50
Effect
Only in CE mode : by pressing this key you switch from any frame directly to the
index frame. The selection of the desired frame can then be made by entering
the frame ID in the index frame.
Pressing this key (return key) switches back to the previous frame.
This key switches from any frame to the MODE SELECTION FRAME.
Enter a frame code in the MODE SELECTION FRAME
(e.g. ST, AU, AU5)
You can change to a subframe by selecting it from the main frame or from a
subframe that has already been invoked. This can be done:
– with program function keys.
The keys are shown in the corresponding frame or subframe.
– by selecting a function with or without entering a parameter.
It is possible to switch to any frame with the FR command. The command is
entered in the command line (screen line 24) of a frame. It has the following
format:
FR XX (XX is the code of the desired frame; see Figure 22 on page 49)
Standard processing in SVP mode
U41161-J-Z126-1-76