Options For Switching Between Frames - Fujitsu BS2000 SE Series Operating Manual

Server Unit /390

4.3.3 Options for switching between frames

The following table shows the options for switching to another frame in the SVP window.
Button Effect
INDEX Only in CE mode: by clicking on this button you switch from any frame directly to the index frame.
The selection of the desired frame can then be made by entering the frame ID in the index frame.
RETURN This button switches back to the previous frame or to the higher-level frame.
ModSel This button switches from any frame to the MODE SELECTION FRAME.
Frame Enter a frame code in the MODE SELECTION FRAME (e.g. ST, AU, AU5)
selection
Change You can change to a subframe by selecting it from the main frame or from a subframe that has
to already been invoked. This can be done:
subframes – with SVP function calls (the buttons are shown in the corresponding frame or subframe)
– by selecting a function with or without entering a parameter.
FR It is possible to switch to any frame with the FR command. The command is entered in the
command command line (screen line 24) of a frame. It has the following format:
FR XX (XX is the code of the desired frame; see figure 5 "Switching between the frames" )
24