Fujitsu S140 User Manual page 52

User frames and subframes
SELECTION
LD
ST
MA MANUAL OPERATION
AD
ME
CH
AU
MF
PA
EXECUTION
!
1
2
3
4
5
6
7
CPU SELECT => A particular CPU, displayed in the next frame line, can be selected here
0 ... 3
52
After entering the appropriate letter combination you can switch to the
following SVP FRAMEs:
PROGRAM LOAD
STATUS DISPLAY
ALTER/DISPLAY
MESSAGE
CH/SUBCH STATUS
AUXILIARY
MSF
PERORMANCE ANALYZER
The following function is executed after the corresponding number has
been entered :
The functions are executed according to the entries in the CPU SELECT and
STOP/START MODE fields (see table on next page)!
CPU STOP
INTERRUPT
TOD ENABLE
SYSTEM RESET
SYSTEM RESET CLEAR
STORE STATUS
RESTART
for the functions in the EXECUTION selection menu (see above).
Standard processing in SVP mode
Load BS2000 ...................................................... 54
Display status ..................................................... 60
Manual operations .............................................. 62
Alter/display storage/register .............................. 64
Display message ................................................ 67
Display status of channel/subchannel ................ 68
Auxiliary controls ................................................ 70
Display FLAG codes .......................................... 79
Performance analysis ......................................... 81
stops either the CPU selected in the CPU SELECT
and STOP/START MODE fields or all CPUs
creates an external interrupt for the CPU selected in
the fields CPU SELECT and STOP/START MODE
time entry is enabled
all CPUs, channel processors, channels and
controllers are reset
as 4; in addition, the working memory is erased
selected CPU is stopped, the status is stored
starts the system again (this function is only
possible if the system has a restart facility).
Selection of a particular CPU
U41161-J-Z126-1-76