Fujitsu S140 User Manual page 59

Standard processing in SVP mode
VM MODE ==>
1
2
IPL EXECUTION ==>
1
2
If there are changes to the VM MODE and
loaded and no IPL is executed.
Special key functions
ENTER
P3
P9
U41161-J-Z126-1-76
NATIVE
AVM/EX/EXS
ENABLE
DISABLE
Sets operating mode. If a loading function has previously been stored in PROGRAM
LOAD FRAME: DETAIL-1 with the
executed.
After selecting the firmware to be loaded in the
Ê
in the
2 IPL EXECUTION ==>
The following prompt will then appear:
***********************************
*
* ARE YOU SURE ? (ENTER Y OR N) N *
*
***********************************
The operating mode must not be reset during system operation! If this
!
instruction is not heeded, BS2000 will be shut down.
Ê Press to reload the firmware, or
Y
input with
ENTER
Ê After reloading the firmware, press the
LOAD FRAME: DETAIL-1.
Switches to PROGRAM LOAD FRAME: BASIC (page 54)
Switches to PROGRAM LOAD FRAME: DETAIL-1 (page 55) and stores the set
parameters.
Initial program loading is possible in PROGRAM LOAD FRAME: DETAIL-1 after
completing this frame and pressing the
Selection of the firmware to be loaded from SVP
for BS2000 operation
for VM2000 operation
IPL execution
executes IPL
does not execute IPL
IPL EXECUTION => 2
key, an IPL with the set parameters is
P9
field, press
*
*
N
.
ENTER
User frames and subframes
, only the other firmware is
VM MODE ==>
.
ENTER
to cancel the procedure. Confirm your
key to carry out IPL in PROGRAM
P9
key.
field and entering
59