Fujitsu S140 User Manual page 39

Standard processing in SVP mode
The password entry window is displayed:
Figure 17: SVPST0 #1 window (password entry)
Ê Enter the password for the specified user ID and press
If the correct password has been entered, the following window appears after a short pause:
after starting the S140: the MODE SELECTION FRAME (see page 51)


after closing and reopening the "SVPST0 #1" window or


opening another SVP window on the secondary console: the last frame shown in the
"SVPST0 #1" window.
!
U41161-J-Z126-1-76
If the "SVPST0 #1" window or another SVP window on the secondary console is
opened, the contents of the window are not output completely. Press the
This causes the screen to be refreshed, i.e. the frame that was last output is
displayed again in its entirety.
If possible, the SVP should only be used via a single window, since using more than
one has an affect on the other SVP windows.
Invoking an SVP frame
.
ENTER
key.
K2
39