Panasonic KX-TVM50 Programming Manual page 41

All Calls Transfer to Mailbox
If this parameter is set to "Yes", the extension is considered to be a "Logical Extension" and therefore
calls directed to the extension via Automated Attendant service are automatically forwarded to the
extension mailbox. The extension does not ring when a call is received.
Note
• When this feature has been set to "Yes", the mailbox subscriber's extension does not
necessarily need to exist as an extension of the PBX.
Value Range
No, Yes
Feature Manual References
2.2.3 Automated Attendant
Call Transfer Sequence
Specifies the Call Transfer Sequence used by the mailbox. Allows each mailbox to be assigned its
own Call Transfer Sequence (Personal Transfer Sequence).
Note
• When "System" is selected, the VPS follows the "Extension Transfer Sequence"
preprogrammed for the VPS in the "System Parameters→Parameters→PBX
Parameters→PBX Environment".
• This sequence has higher priority than "Alternate Extension Transfer Sequence" in 2.5.4
Parameters.
Value Range
System
Max. 16 characters consisting of 0–9, , # and special codes:
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
X: Extension Dialling
0–9, , #: Dial Code
Programming Manual References
"Extension Transfer Sequence" in 2.5.4 Parameters
Feature Manual References
2.3.5 Call Transfer Status
No Answer Time
Specifies the length of time that the VPS waits before handling unanswered calls to the extension.
2.1 Mailbox Settings
Programming Manual 41