System Security; Administrator - Panasonic KX-TVM50 Programming Manual

2.8 System Security

2.8 System Security
System security settings are divided into the following categories:
–

Administrator

– Subscriber
2.8.1 Administrator
Password
Assigns the password required when connecting to the VPS using KX-TVM/NCV Maintenance
Console.
Follow the steps below to change the password:
1.
Click Click to change password....
2.
Enter a new password in Enter new password:.
3.
Enter the new password in Confirm new password:.
4.
Click OK.
Note
• Programming Code has to be entered when the System Administrator start KX-TVM/NCV
Maintenance Console.
Value Range
Max. 16 digits.
Feature Manual References
2.4.8 System Security
Login Failure before Disconnection
Specifies the times of invalid password entry for the System Administrator to login the VPS. If the
invalid password is entered over this parameter's setting, the VPS disconnects a call. This parameter
is applied to login by the System Manager or the Message Manager from their telephone.
Value Range
1–99 times
System Manager Access from Telephone
Enables or disables access to the VPS from the System Manager's telephone.
Note
• The System Administrator will be asked to set the System Manager's password if both of the
following conditions are met:
a)
b)
• The password must be entered 2 times for verification.
164 Programming Manual
The System Administrator changes this parameter from "Disable" to "Enable".
The System Manager's password has not been set previously.