Utility-Diagnostic; Utility-Programmer Code; Utility-Commands - Panasonic KX-TVM50 Programming Manual

1.
Select "Restart System".
(You can click the icon in the tool bar instead of step 1 and 2.)
2.
If there are active ports, the System Administrator will be asked to either to continue or to
cancel.
Select OK to continue, or Cancel to close the ports.
3.
Click OK.
1.8.8 Utility—Diagnostic
Diagnostic is used to diagnose the following hardware of VPS.
– Codec/DSP Voice Path: diagnoses whether the voice path between Codec and DSP
functions properly.
– Play/Record Voice Path: diagnoses whether the voice path in the playing/recording unit
functions properly.
Follow the steps below for System Diagnostic:
1.
Click Utility in the menu bar.
2.
Select Diagnostic.
3.
If there are active ports, the System Administrator will be asked to either to continue or to cancel.
Select OK to continue, or Cancel to close the ports.
4.
Select Codec/DSP Voice Path or Play/Record Voice Path.
5.
Diagnosis starts.
1.8.9 Utility—Programmer Code
The System Administrator can change the programmer code that is needed to use KX-TVM/NCV
Maintenance Console.
Follow the steps below to change the programmer code:
1.
Click Utility in the menu bar.
2.
Select Programmer Code.
3.
If the programmer code is already set, enter the old programmer code in Enter old programmer
code:.
4.
Enter a new programmer code in Enter new programmer code:.
5.
Enter the new programmer code in Confirm new programmer code:.
6.
Click OK.
1.8.10 Utility—Commands
The System Administrator can enter commands to maintain the system without closing KX-TVM/NCV
Maintenance Console.
Follow the steps below for Commands:
1.
Click Utility in the menu bar.
1.8 Utility
Programming Manual 31