Entering An Ecm Password (Ecm); Section 2: Machine Information (Continued) - Minolta CF5001 User Manual

Entering an ECM Password (ECM)

The Electronic Copy Monitor (ECM) allows the Key Operator to monitor all copying
activities by controlling ECM password accounts. Copy quantity limits for specific accounts
can be set.
The ECM is not factory-set. An ECM password is required only when the ECM is activated,
a User Password is assigned, and "Enter E.C.M. password" is displayed on the touch
screen.
Copying will be available by following procedure:
For details of the ECM setting, see p. 14-12 to p. 14-19.
1.
Enter ECM password.
Enter your 8-digit ECM password, using the keypad.
To set an ECM password, see p. 14-14 to p. 14-16.
If an invalid ECM password is entered, continue by entering the correct
password.
2.
Press [START].
Your current copy count and copy limit will be displayed for 3 sec.
Current count / limit
018888/025000
3.
Start a copying job.
When the message changes to "Ready to copy", copying job is available on the machine.
When your copy count reaches the copy limit, the message "Copy limit
reached" will be displayed. In that case, contact the Key Operator to reset your
copy limit.
4.
Press [ACCESS].
The initial state will be restored, with the message "Enter E.C.M. password" displayed on
the screen.
Turning On the Power Switch (continued)
2
Machine
Information
Machine
Configuration
Turn On/Off
the Power
Loading
Paper
2-21