Side Trim And Side Panel Removal (Right Side Shown); Hinge Receiver Removal; Back Panel Removal - Viking RDSCD230-5B Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Side Trim and Side Panel Removal
(Right side shown)
1. Remove the control panel assembly (see Control
Panel Assembly Removal).
2. Remove backguard assembly (see Backguard
Assembly Removal).
3. Remove screws and lift kick plate from keyhole
screws.
4. Remove screws and side trim from range.
5. Remove keyhole screw from front of range.
6. Remove screw from back of range.
7. Remove screws, main top support, and side panel
from range.
8. Reverse procedure for installation.
©2012 Viking Preferred Service

Hinge Receiver Removal

1. Remove side panel (see Side Panel Removal).
2. Remove screws and side trim from range.
3. Remove screws and panel from range.
4. Remove screws and hinge receiver from range.
5. Reverse procedure for installation.

Back Panel Removal

1. Remove backguard assembly (see Backguard
Assembly Removal).
2. Remove screws and access door from back cover.
Disassembly
35