Switch Upper Panel; Wiring The Power Inputs - Planet Networking & Communication igs-801m User Manual

10/100/1000BASE-T Interfaces (Port-1 to Port-8)
■
LED Color
1000 Green
10/100 Green

2.1.3 Switch Upper Panel

The upper panel of the Industrial Managed Switch
2-3 shows the upper panel of the switch.

2.1.4 Wiring the Power Inputs

The 6-contact terminal block connector on the top panel of Industrial Managed Switch is used for two DC redundant power
inputs. Please follow the steps below to insert the power wire.
1. Insert positive/negative DC power wires into contacts 1 and 2 for Power 1 or 5 and 6 for Power 2.
Lights Indicates the port is successfully connecting to the network at 1000Mbps
Blinks Indicates that the port is actively sending or receiving data over that port
Indicates that no device is attached or it is successfully connecting to the network
Off
at 10Mbps or 100Mbps
Lights Indicates the port is successfully connecting to the network at 100Mbps
Blinks Indicates that the port is actively sending or receiving data over that port
Off No device is attached
consists of one terminal block connector within two DC power inputs.
Figure 2-3: IGS-801M Upper Panel
V1- V1 +
Function
V2 - V2 +
21
User's Manual of IGS-801M
Figure