Ip Address Setup - Hitron CGNV2 User Manual

20
TABLE 2:
US
DS
POWER
When you turn on the CGNV2, the LEDs light up in the following order:

Power

US

DS

Status

The ETH 1~2 LEDs light up as soon as there is activity on the relevant port, the
LINE port light up if your service contract includes voice service, and the
WIRELESS LED lights up once the wireless network is ready.
1.4

IP ADDRESS SETUP

Before you log into the CGNV2's GUI, your computer's IP address must be in the
same subnet as the CGNV2. This allows your computer to communicate with the
CGNV2.
NOTE: See IP Addresses and Subnets on page 25 for background information.
The CGNV2 has a built-in DHCP server that, when active, assigns IP addresses to
computers on the LAN. When the DHCP server is active, you can get an IP address
automatically. The DHCP server is active by default.
If your computer is configured to get an IP address automatically, or if you are not
sure, try to log in to the CGNV2 (see

If the login screen displays, your computer is already configured correctly.

If the login screen does not display, either the CGNV2's DHCP server is not
active or your computer is not configured correctly. Follow the procedure in
Manual IP Address Setup
address automatically. Try to log in again. If you cannot log in, follow the manual
IP address setup procedure again, and set a specific IP address as shown. Try
to log in again.
INTRODUCTION
LEDs
Blinking The CGNV2 is searching for an upstream frequency
on the CATV connection.
On The CGNV2 has successfully located and locked
onto an upstream frequency on the CATV
connection.
Blinking The CGNV2 is searching for a downstream
frequency on the CATV connection.
On The CGNV2 has successfully located and locked
onto a downstream frequency on the CATV
connection.
On The CGNV2 is receiving power.
The CGNV2 is not receiving power.
Off
on page
HITRON CGNV2 USER'S GUIDE
Login to the CGNV2 on page 22).
21 and set your computer to get an IP