Output 2 Menu; Figure 3.10 Flow Chart For Output 2 - Omega CNi8 Manual

3.2.11 Output 2
Output 2 and Alarm 2 share the same contacts on the rear panel connector. If
Alarm 2 is Enabled, Output 2 is automatically Disabled.
ENTER OUTPUT 2 MENU:
Press a
Press d
Press a
Press d
CONTROL TYPE SUBMENU:
Press d
Press b
Press d
The ON/OFF control is a coarse way of controlling the Process. The "Dead
Band" improves the cycling associated with the ON/Off control. The PID control
is best for processes where the Setpoint is continuously changing and/or tight
control of the Process Variable is required.

Figure 3.10 Flow Chart for Output 2

1) Press a , if necessary, until CNFG prompt appears.
2) Display advances to INPT Input Menu.
3) Press a , if necessary, until Display advances to OUT2

Output 2 Menu.

4) Display advances to CTRL Control Type Submenu.
3) Display flashes ON.OF ON/OFF, or PID PID.
4) Scroll through the available selections: "ON/OFF" or "PID".
5) Display shows STRD stored message momentarily and then
advances to AçTN only, if it was changed, otherwise press a to
advance to AçTN Action Type Submenu.
is required that you put
It
the controller in the
Standby Mode for any
configuration change other
than Set Points & Alarms.
42