Id Number - Omega CNi8 Manual

3.2.1 ID Number

SEE ID MENU SELECTION IN CONFIGURATION SECTION FOR
ENABLE/DISABLE OR CHANGE ID CODE.
If ID Code is Disabled or set as Default (0000) the menu will skip ID step
to Setpoint Menu.
If ID Code is set to Full Security Level and user attempts to enter the
Main Menu, they will be prompted for an ID Code.
If ID Code is set to Setpoint/ID Security Level and user attempts to enter
the Configuration Menu, they will be prompted for an ID Code.
ENTERING YOUR NON-DEFAULT FULL SECURITY ID NUMBER.
Press a
Press d
Press b & c 3) Press b to increase digit 0-9. Press c to activate next digit
Press d
To change ID Code, see ID Menu in the Configuration section.
ENTERING YOUR NON-DEFAULT SETPOINT/ID SECURITY ID NUMBER.
Press a
Press a
Press a
Press d
Press b & c 9) Use b and c to change your ID Code.
Press d
To prevent unauthorized tampering with the setup parameters, the
instrument provides protection by requiring the user to enter the ID Code
before allowing access to subsequent menus. If the ID Code entered
does not match the ID Code stored, the controller responds with an error
message and access to subsequent menus will be denied.
Use numbers that are easy for you to remember. If the ID Code is
forgotten or lost, call customer service with your serial number to access
and reset the default to 0000 .
1) Display shows ID .
2) Display advances to ____ .
(flashing). Continue to use b and c to enter your 4-digit ID
code.
4) If the correct ID code is entered, the menu will advance to the
Setpoint 1 Menu, otherwise an error message ERRo will be
displayed and the instrument will return to the Run Mode.
5) Display shows SP1 Setpoint 1 Menu.
6) Display shows SP2 Setpoint 2 Menu.
7) Display shows ID ID Code Menu.
8) Display advances to ____ .
10) If correct ID Code is entered, the display will advance to the
INPT Input Menu, otherwise the error message ERRo will be
displayed and the controller will return to the Run Mode.
16