Logic/Ssr Connections (Cn63100 Only); Remote Setpoint Wiring; Main Linear Dc Output Wiring; Second Linear Dc Output Wiring - Omega CN63100 Series User Manual

Logic/SSR Connections (CN63100 only)

Logic/SSR Drive Output:
Rating: 45 mA @ 4 V min., 7 V nominal (current limited)
Figure 8, Logic/SSR Output

REMOTE SETPOINT WIRING

Models with the Remote Setpoint option have two input terminals to
receive a 0 to 20 mA signal. Connect the Remote Setpoint signal to terminals
labeled #13 (+) and #14 (-), "2nd Input Option". The common of this input is
isolated from input common, but is not isolated from the Linear DC output
commons. For proper operation, keep this common isolated from all other
controller commons.

MAIN LINEAR DC OUTPUT WIRING

Models with the Linear DC output option provide either a linear 10 V or a
linear 20 mA signal. The output range is selected by jumpers on the output
board. (See Linear DC Analog Output Jumper Selection, page 11). The
terminals are #1 (-) and #2 (+). The common of this output is isolated from
input common, but is not isolated from other commons. For proper operation,
keep this common isolated from all other controller commons.

SECOND LINEAR DC OUTPUT WIRING

Models with the Second Linear DC output option provide a conditioned
and scaled retransmitted signal output. The terminals are #13 (+) and #14 (-).
The common of this output is isolated from the input common, but not from
the other commons. For proper operation, keep this common isolated from all
other controller commons.

USER INPUT WIRING

The use of shielded cable is recommended. Follow the EMC installation
guidelines for shield connection.
Terminal #6 is the User Input, which is programmable for a variety of
functions. Any form of mechanical switch may be connected to terminal #6
(USER INPUT) and terminal #8 (COMM.). Sinking open collector logic with
less than 0.7 V saturation and off-state leakage current of less than 1 μA may
also be used.
-7-