Ramp And Soak Menu; Figure 3.11 Flow Chart For Ramp And Soak - Omega CNi8 Manual

3.2.12 Ramp & Soak
Alarm must be DISABLED if Ramp is ENABLED.
is required that you put the controller in the Standby Mode for any
It
configuration change other than Set Points & Alarms.

Figure 3.11 Flow Chart for Ramp and Soak

ENTER RAMP AND SOAK MENU:
Press a
Press d
Press a
RAMP ENABLE/DISABLE SUBMENU:
Press d
Press b
Press d
1) Press a , if necessary, until CNFG prompt appears.
2) Display advances to INPT Input Menu.
3) Press a , if necessary, until Display advances to RAMP Ramp
and SOAK Soak Menu.
4) Display advances to "Ramp Enable/Disable" Submenu and
flashes ENBL or DSBL .
5) Scroll through the available selections: "Enable" or "Disable".
6) Display shows STRD stored message momentarily and then
advances to SOAK Soak Enable/Disable Menu.
If RAMP Disable was selected, display skips to the next menu
item (ID Code).
45