Table of Contents
Advertisement
ALARM ENABLE/DISABLE AT POWER ON:
Press d
Press d
If the alarm is enabled at Power On, the alarm will be active right after
reset. If the alarm is disabled at Power On, the alarm will become
enabled when the process value enters the non alarm area. The alarm is
not active while the process value is approaching Setpoint 1.
ALARM 1 LOW VALUE SUBMENU:
Press d
Press b & c 18) Use b and c to enter Alarm 1 Low Value.
Press d
ALARM 1 HI VALUE SUBMENU:
Press d
Press b & c 21) Use b and c to enter Alarm1 Hi Value.
Press d
15) Display flashes previous selection. Press b to ENBL enable
or DSBL disable.
16) Display shows STRD stored message. momentarily and then
advances to ALR.L only if it was changed, otherwise press a to
advance to the ALR.L Alarm 1 Low Value Submenu.
17) Display flashes 1
enter new value.
19) Display shows STRD storage message momentarily and
then advances to ALR.H only, if it was changed, otherwise press
a to advance to ALR.H Alarm 1 Hi Value Submenu.
20) Display flashes 1
enter new value.
22) Display shows STRD stored message momentarily and then
advances to the next menu only, if it was changed, otherwise
press a to advance to the next menu.
st
digit of previous value. Use b and c to
st
digit of previous value. Use b and c to
28
Advertisement
Table of Contents
