Table of Contents
Advertisement
2.2 Wall Mounting
Position unit where required. Mark and drill the two #4 screw holes.
After bracket is mounted on the wall, align back of unit over the three bracket clips, once
engaged, slide downward, the unit will snap in place.
DRILL 3.17 [0.125]
FLAT HEAD SCREWS
TO MOUNT BRACKET
29.5 [1.16]
CLIPS (3)
14.9 [0.59]
46.1 [1.81]
UNIT OUTLINE
It is recommended that you ground your unit by connecting a wire to the
Return/Ground position of the relay connector, see Figure 2.6.
USE TWO, #4
38.1 [1.50]
130.2 [5.13]
Figure 2.2 Wall Mounting
ADDITIONAL MOUNTING OPTION-
TO RETAIN UNIT TO MOUNTING BRACKET
USE #4 X 1/4" LONG SELF-TAPPING SCREW
34.4 [1.36]
88.1 [3.47]
REAR WIRE
ENTRY AREA
38.1 [1.50]
5
23.8 [0.94]
6.1 [0.24]
Dimensions are in mm
with inches in [ ].
Advertisement
Table of Contents
