Table of Contents
Advertisement
4.4.7.3 Upgrade (continued)
After you have successfully upgraded your device, you can verify the firmware
version number on the "Overview" page (see Section 4.4.1).
It's recommended to set the iServer to default settings after the firmware is upgraded.
See above Section 4.4.7.2 on how to set the iServer to default settings.
Applying default settings will change the iServer's settings to factory defaults.
If those settings are important to you and you do not want to reconfigure the iServer, you
will need to do the following steps.
From the "System" menu:
1) "Download" the iServer's configuration settings, Section 4.4.7.4.
2) "Upgrade" the iServer with the new firmware, Section 4.4.7.3.
3) Set the iServer to "Default" settings. The iServer's IP address is now
192.168.1.200.
4) "Upload" the same configuration you obtained from step 1 onto the iServer,
Section 4.4.7.5.
4.4.7.4 Download Configuration
Clicking on this button will download the configuration file that contains all the settings
stored in the iServer and use it as a reference.
Download
Address
http://192.168.1.200
Overview
Network
Configuration
Management
Security
Recording
System
Diagnostics
Log Out
Readings
Reboot
Defaults
Upgrade
Figure 4.30 System: Download Configuration
Web Link
Setup
Download Configuration
Download Configuration File
42
Upload Configuration
Advertisement
Table of Contents
