2.3 Parts of the iServer Unit
9Vdc Battery
(under cover)
Warning:
The standard
right angle
probe is ESD
Sensitive
Detachable
Temp + RH
Probe
Removable Plug
Connector for
Input and Outputs
(under cover)
Bottom Wire Entry
I/O Connectors
Table 2.1 Parts of iServer Unit
ETHERNET
RJ45 interface for 10/100BASE-T connection.
RESET
Button: Momentary (Push and Release) resets power on unit; Push and Hold for
10 seconds to reset unit to factory defaults and reset power.
100 BASE-T
LED (Green) On: Indicates 100 Mbps; LED Off: Indicates 10 Mbps.
LINK/ACT
LED (Green) On/Blinking: Indicates good network link and network activities
(receiving or sending packets).
DHCP
LED (Yellow): When DHCP is enabled, once the iServer receives the IP
parameters from the DHCP server this LED will turn Solid yellow.
LED (Green) Blinking Fast: Indicates that the unit is recording. LED Blinking:
RECORDING
during back-up battery operation according to sampling rate, or recording interval
if recording is ON.
°C/°F
Button: Press to change LCD display units of measurement between °C and °F.
Press and Hold along with TIME/IP button during power-on, this will enable
DHCP mode.
TIME/IP
Button: Press repeatedly to change LCD display from: 1) Date and Time;
2) iServer's IP address; 3) Temperature and Humidity. Press and Hold
along with °C/°F button during power up, this will enable DHCP mode.
C/ F TIME/IP BKLT
Buttons
iServer
Reset Button
Figure 2.3 Parts of the iServer Unit
TOP VIEW
32 Digit LCD Display
RECORDING
DHCP
LINK/ACT
100 BASE-T
iServer LEDs
9-12 Vdc
-
+
ETHERNET
1
8
iServer
RJ45 interface
6
The 9V battery is the
back-up power for the
recording function only.
SD Flash
Memory
Card
Cover
Screw
(2 plcs)
SD Flash
Memory
Card
Standby
Button
dc Power Input