Table of Contents
Advertisement
4.1.4 iConnect Software (Method 4)
The iServer can be assigned an IP Address by using the iConnect software.
a)
Download the iConnect software from the website listed on the cover of this manual
(software section).
b)
Install iConnect software on a networked PC. This software is compatible with
Windows 95, 98, NT, 2000, and XP.
c)
Use iConnect to assign an IP address to the iServer and access its web pages for
configuration.
You can also use any standard web browser to access the iServer's web pages.
Consult with your IT department for obtaining an IP address.
Figure 4.8 Assigning an IP Address using iConnect
1)
Place the IP address in this box.
2)
Take the MAC address from the label attached to the bottom of the iServer and
place it in this box.
3)
Click here to send the above IP address to the iServer.
4)
After the IP address is assigned to the iServer, click here to access it's web pages.
5)
Click here to Ping the iServer whose IP address is shown in the IP address box.
6)
Click here to find all the iServer's on your network .
7)
The IP addresses for the iServer's found by the iConnect will be listed here.
8)
These fields indicate the IP address and the subnet mask of the PC on which the
iConnect is running.
17
Advertisement
Table of Contents
